News

For The Construction Basket, I Believe That You Can Learn About This Kind Of Basket Through The Previous Study, And At The Same Time, Increase Your Knowledge In This Area. Therefore, In Order To Promote The Learning Process And Speed Up The Learning Speed Of The Product, We Will Continue This Topic With The Following Contents. &What Are The Main Inspection And Inspection Methods Of The Hoist In The Construction Basket? &If The Hoist In The Construction Basket Is Checked, It Should Be Lifted And Lowered In A Journey Of Not Less Than 5 Meters Under The Conditions Of No-load, Full Load And Overload, And Run For 30 Minutes To Check Whether There Is Any Abnormality. For Its Detection, It Uses Current Sensor, Voltage Sensor And Temperature Sensor To Detect Whether There Is Any Abnormality In Its Current, Voltage And Shell Temperature. &Can The Girder In The Building Basket Rotate? In Addition, How To Deal With The Redundant Wire Rope On The Floor Of The Basket? &The Girder In The Building Basket Will Not Rotate Because There Are Adjusting Rod Screws At The Back. In General, The Redundant Steel Wire Rope On The Floor Of The Basket Should Be Well Coiled And Then Tied And Placed. It Can't Be Placed Casually Or Randomly, Thus Causing Unnecessary Problems Or Troubles. Moreover, This Is Also An Important Point In The Basket, So We Should Pay Attention To It And Not Make Mistakes. &How To Deal With The Tilt Of The Suspended Platform In The Process Of Using The Construction Basket When The Tilt Angle Is Large? &If The Suspended Platform In The Construction Basket Has A Large Inclination Angle, It Should Be Stopped In Time And Then Handled. If It Is Specific, It Is: Turn The Change-over Switch On The Electrical Box To The Stand-alone Operation Gear Of The Platform, And Then Press The Up Or Down Button Until The Suspended Platform Is Close To The Horizontal State. After That, Turn The Change-over Switch To The Double Machine Operation Position, And Let The Cradle Continue To Operate.