News

When Our Operators Want To Operate The Basket, They Must Be Familiar With The Operating Procedures Of The Basket Before Operation. In Case Of Failure During Operation. 1. The Operators Must Be In Good Health And Pass The Professional Training And Examination, And Can Operate Independently Only After Obtaining The Operation Certificate Issued By The Relevant Departments. Students Must Operate Under The Guidance Of The Master. 2. After Installation, The Following Inspection Tests Shall Be Carried Out, And They Can Be Delivered For Use Only After They Are Confirmed To Be Normal. 1) Check The Installation Of The Roof Mechanism, Which Shall Be Well Coordinated And Anchored Reliably; The Cantilever Length And Connection Mode Shall Be Correct; 2) The Steel Wire Rope Shall Be Free From Kink, Crush And Looseness, Wear And Broken Wire Shall Not Exceed The Limit, And The Hanging And Winding Methods And Hanging Weight Shall Be Correct; 3) The Safety Protection Devices Of Anti Falling And External Rotating Mechanism Are Complete And Reliable; 4) The Motor Has No Abnormal Noise And Overheating, And It Starts Normally And Brakes Reliably; 5) The Basket Shall Be Subject To The Static Overload Test Of 125% Of The Rated Lifting Capacity And The Dynamic Overload Test Of 110% Of The Rated Lifting Capacity. The Lifting Shall Be Normal And The Limit Device Shall Be Sensitive And Reliable. 3. The Following Checks Shall Be Carried Out Before Operation: 1) Roof Mechanism, Suspended Load And Steel Wire Rope Meet The Requirements; 2) The Power Supply Voltage Shall Be Normal And The Grounding (neutral) Protection Shall Be Good; 3) The Mechanical Equipment Is Normal, And The Safety Protection Device Is Complete And Reliable; 4) There Are No Sundries In The Basket, Overload Is Strictly Prohibited. 4. After Startup, The Operation Test Of The Lifting Basket Shall Be Carried Out, And The Operation Can Be Started Only After It Is Confirmed To Be Normal. 5. In Case Of Abnormal Operation During Operation, Stop The Machine Immediately And Take Safety Protection Measures. It Shall Not Be Used Until It Is Inspected And Repaired By Professional Personnel. 6. When Using The Hanging Basket For Electric Welding, The Hanging Basket And Steel Wire Rope Must Be Fully Protected And Shall Not Be Used As The Wiring Circuit. 7. After Operation, The Basket Shall Be Cleaned, Hung 3M From The Ground, Cut Off The Power Supply And Remove The Ladder.