News

Where You Are: Basket & Gt; Huake News How Should We Correctly Analyze When The Hoist Fails? 1、 For Example, When The Elevator Makes Abnormal Noise During Operation, We Can Analyze And Solve It As Follows: 1. The Chain Bucket And Base Plate Of Bucket Elevator Touch Each Other Due To Looseness, So The Elastic Device On The Base Can Be Adjusted To Tighten The Chain. 2. If The Chain Bucket Collides With The Housing, Or The Sprocket Is Displaced, Or The Transmission Shaft Is Loose, Adjust The Position Of The Sprocket And Tighten The Key. 3. If The Bearing Fails To Operate Flexibly, It Needs To Be Replaced In Time. 4. The Internal Part Of The Base Shell Is Stuck By Foreign Matters And Needs To Be Shut Down For Removal. 5. If The Tooth Shape Of Sprocket Is Not Neat, It Shall Be Corrected Or Replaced. 6、 The Transmission Chain Idles, And The Length Of The Chain Needs To Be Adjusted. 7. The Casing Is Not Installed Properly And The Verticality Needs To Be Adjusted. 2、 For Example, The Motor Base Of The Elevator Produces Vibration 1. It May Be That The Machine Itself Rotates Poorly, So It Is Necessary To Remove The Rotor To Check The Static Balance. 2. The Motor And Reducer Of The Hoist Have Poor Accuracy During Installation, So They Need To Be Readjusted According To The Specified Standards. 3. The Installation Error Of The Drive Sprocket Needs To Be Adjusted, The Tooth Shape Of The Drive Sprocket Needs To Be Corrected, And The Tightness Of The Drive Sprocket Needs To Be Adjusted. 3、 For Example, Dust Leakage Occurs In The Elevator 1. If The Gasket Is Damaged Or Missing, The Gasket Shall Be Replaced In Time. 2. If The Material Leaks From The Gap Of The Machine Head Or The Machine Base, The Sealing Gasket Shall Be Added. 3. The Height Difference Of The Materials Is Too Large, So It Is Necessary To Change The Feeding Mode, Reduce The Feeding Pressure And Increase The Buffer Device For Feeding. 4、 For Example, The Lifting Capacity Of The Elevator Can Not Reach The Design Capacity 1. Materials Stuck On The Chain Bucket Shall Be Cleaned Regularly. 2. The Capacity Of The Front Equipment Of The Elevator Is Not Enough, Resulting In Less Material Input, So The Elevator Will Not Reach The Design Capacity, And The Production Capacity Of The Front Equipment Needs To Be Improved. 3. The Speed Ratio Of The Drive Sprocket Needs To Be Adjusted To Increase The Lifting Speed. 4. The Method Of Measuring Materials Is Not Correct, Resulting In Errors. It Is Necessary To Check The Proportion Of Materials And Modify The Calculation Method.